Precision Mechanical Wedge Action Grips

Instron® 2716-028/030 Series Precision Manual Wedge Grips provide reliable gripping for a vast range of materials, as well as repeatable alignment that meets Nadcap requirements.

操作原理

The wedge action principle of these grips allows them to be tightened onto a specimen without altering the vertical position of the faces in relation to the specimen. This is accomplished by a design, which moves the grip body to close the faces. This feature makes it possible to pre-select the exact point at which the specimen will be held with consistent gauge length and no compressive force applied which may cause specimen buckling. 

A strong clamping force can be applied to materials that are difficult to hold through a high mechanical advantage achieved by the tightening mechanism. The grip faces are spring loaded against a shoe which is in a fixed position in respect to the testing frame holding mechanism, only a light initial gripping force needs to be applied to the specimen. As the grip is tightened, it's frame is drawn up and the inclined sides push against the matching side of the faces which move laterally against the specimen. A shoe incorporated to the driving shaft prevents the faces from moving. 

The open front design of the grip frames allows faces to be easily interchanged as well as easy specimen loading. 

Because the faces are held in fixed position, there is no recoil, or loosening, when the specimen ruptures and if an extensometer is attached, it will remain in place.

適用範囲

  • Type of Loading: tensile, static and tension cyclic tests. Not suitable for high cycle fatigue test. 
  • Specimen Material: wires, plastics, metals, elastomers 
  • Specimen Types: flat, round
品名 Capacity Upper Fitting Cat #
Precision Wedge Action Grips; Rated Capacity: 100 kN 100 kN 22,500 lbf 0.5 in clevis pin (Type Dm) 2716-028
Precision Wedge Action Grips; Rated Capacity: 250 kN 250 kN 50,000 lbf M48x2mLH (Type IIm) 2716-030