サービスとサポート » リソース » マニュアル » Page 4

Product Manuals

DX Static Hydraulic Universal Testing System – System Concepts Manual

These instructions provide additional information beyond what is necessary to operate the various models of the DX testing systems. These instructions are intended for a laboratory or facilities supervisor, or Instron service personnel. These instructions assume the following: • You are an operator familiar with the operation of materials testing systems in general. • Your system has been installed in its final location according to the requirements outlined in the system’s Pre-Installation Manual. • Your system consists of a frame, a hydraulic power supply, a control unit, a computer system with an Instron materials testing software package, and any testing accessories necessary to secure the specimen in the test space. • Software test methods that are appropriate for your testing requirements are available. These instructions do not include the development of test methods within the materials testing software. This is covered in more advanced training that can be provided by Instron Service and Training departments.

ダウンロード

マニュアル 07/14/2020 1.79 MB

Model DX Static Hydraulic Universal Testing System – Operating Instructions

These instructions describe the function, operation and maintenance for various models of the DX testing systems. If unsure of your specific model, refer to “System identification” on page 14. These instructions assume the following: • You are an operator familiar with the operation of materials testing systems in general. • Your system has been installed in its final location according to the requirements outlined in the system’s Pre-Installation Manual. • Your system consists of a frame, a hydraulic power supply, a control unit, a computer system with an Instron materials testing software package, and any testing accessories necessary to secure the specimen in the test space. • Software test methods that are appropriate for your testing requirements are available. These instructions do not include the development of test methods within the materials testing software. This is covered in more advanced training that can be provided by Instron Service and Training departments.

ダウンロード

マニュアル 07/14/2020 1.96 MB

DX Static Hydraulic Universal Testing System – Pre-Installation Manual

The information in this document is intended to aid customers in the site preparation, unpacking, lifting, and installation of the Instron Model DX Static Hydraulic Universal Testing Systems. These instructions assume the following: • Your system consists of a frame, a hydraulic power supply, a control unit, a computer system with an Instron materials testing software package, and any testing accessories necessary to secure the specimen in the test space. It is important that the site be adequately prepared in order to avoid unnecessary delays in the installation process and to ensure that the testing system operates without interference from various environmental conditions (i.e. excess building vibrations or extreme temperature and humidity levels).

ダウンロード

マニュアル 07/14/2020 1017.22 KB

Thermal Safety Sheet for 3119-600 Series-Temperature Controlled Chambers

This document provides important Health and Safety information specifically regarding handling, installation, operation, maintenance and decommissioning of Instron furnaces and environmental chambers. The best safety precautions are a thorough understanding of the equipment by reading the instruction manuals and always using good judgement.

ダウンロード

マニュアル 07/14/2020 1.9 MB

マニュアル設置前用

ダウンロード

マニュアル 07/13/2020

3119-600 Series Temperature Controlled Chambers Operating Instructions

This manual contains the information necessary to operate the chamber by giving safety information, describing the controls and providing detailed procedures for general operation.

ダウンロード

マニュアル 07/13/2020 1008.29 KB